STRESS ANALYSIS OF AN AXI-SYMMETRIC COMPONENT
Aim:
To conduct the stress analysis in an axis symmetric component using ANSYS software.
Procedure:
The three main steps to be involved are
1. Pre Processing
2. Solution
3. Post Processing
Figure:
AXI- SYMMETRIC COMPONENT
ALL DIMENSIONS IN MM
Material properties:
Young's modulus (EX) = 2 x 105 N/mm2
Poisson's ratio (PRXY) = 0.3
Pressure value = 25 N/m2
Images:
DOF SOLUTION
VON-MISES STRESS
X COMPONENT STRESS
Z COMPONENT STRESS
Result:
Thus the stress analysis is performed on Axisymmetric component. The maximum stress was found on Z-component as hoop stress.
